Cisco ASR 9000 Series Reference Guide

name (MSTAG/REPAG)
To set the name of the MSTP region, use the name command in MSTAG interface configuration or REPAG
interface configuration submode.
name name
Syntax Description
String of a maximum of 32 characters conforming to the definition of
SnmpAdminString in RFC 2271.
name
Command Default
The MAC address of the switch, formatted as a text string using the hexadecimal representation specified in
IEEE Std 802.
Command Modes
MSTAG interface configuration, REPAG interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to set the name of the MSTP region to leo:
RP/0/RSP0/CPU0:router(config-mstag-if)# name leo
Related Commands
DescriptionCommand
Enables MSTAG packet debugging.debug spanning-tree mstag packet, on page
483
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
548
Multiple Spanning Tree Protocol Commands
name (MSTAG/REPAG)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model