Cisco ASR 9000 Series - Port1

port1
To enable G.8032 for a specified ring port, use the port1 command in g8032 configuration port1 submode.
To disable, use the no form of this command.
port1 {interface interface name| none}
Syntax Description
Specifies physical Ethernet or Bundle Ethernet
interface. A physical port of the local node
connected to G.8032 ring. Enables G.8032 for the
specified physical port to form a closed ring.
interface interface name
Specifies local node endpoint of an open-ring.none
Command Default
None
Command Modes
Ethernet ring g8032 configuration port1 submode
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows the output from the port1 command:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# ethernet ring g8032 g1
RP/0/RSP0/CPU0:router(config-l2vpn-erp)# port1 interface TenGigE 0/6/0/3
RP/0/RSP0/CPU0:router(config-l2vpn-erp-port1)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
300
Multipoint Layer 2 Services Commands
port1