Cisco ASR 9000 Series - Bridge-Domain (VPLS)

bridge-domain (VPLS)
To establish a bridge domain and to enter L2VPN bridge group bridge domain configuration mode, use the
bridge-domain command in L2VPN bridge group configuration mode. To return to a single bridge domain,
use the no form of this command.
bridge-domain bridge-domain-name
no bridge-domain bridge-domain-name
Syntax Description
Name of the bridge domain.
The maximum number of characters that can be specified in the
bridge domain name is 27.
Note
bridge-domain-name
Command Default
The default value is a single bridge domain.
Command Modes
L2VPN bridge group configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
Use the bridge-domain command to enter L2VPN bridge group bridge domain configuration mode.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to configure a bridge domain:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
240
Multipoint Layer 2 Services Commands
bridge-domain (VPLS)