neighbor evpn
To enable EVPN-VPWS endpoint on the p2p cross-connect, use the neighbor evpn command in the p2p
configuration submode.
neighbor evpn evi vpn-idtarget ac-id
Syntax Description
Virtual Private Network Identifier where this p2p xconnect is setup.
evi vpn-id
Specifies the targeted remote attachment circuit id of the EVPN.
target ac-id
Command Default
None
Command Modes
p2p configuration submode
Command History
ModificationRelease
This command was introduced.Release 6.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
The following example shows how to enable EVPN-VPWS endpoint on the p2p cross-connect.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:routerRP/0/RP00RSP0/CPU0:router# interface TenGigE0/1/0/12
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group xc1
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p vpws
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface gigabitethernet 0/1/0/9
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor evpn evi 100 target 80
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
117
Point to Point Layer 2 Services Commands
neighbor evpn
To Next Page
Loading...
Need help?
General
