Cisco ASR 9000 Series - Page 130

This example shows a point-to-point IPv6 cross-connect configuration:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn xconnect group l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p rtrA_to_rtrB
RP/0/RSP0/CPU0:router(config-xc-p2p)# neighbor ipv6 1111:2222::cdef pw-id 1
This example shows how to set a source IPv6 address to a point-to-point IPv6 cross-connect :
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn xconnect group l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p rtrA_to_rtrB
RP/0/RSP0/CPU0:router(config-xc-p2p)# neighbor ipv6 1111:2222::cdef pw-id 1
RP/0/RSP0/CPU0:router(config-xc-p2p-pw)# source 1111:2222::abcd
Related Commands
DescriptionCommand
Enters L2VPN configuration mode.l2vpn, on page 100
Enters p2p configuration submode to configure point-to-point
cross-connects.
p2p, on page 134
Enters pseudowire class submode to define a pseudowire class
template.
pw-class (L2VPN), on page 124
Configures cross-connect groups.xconnect group, on page 227
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
116
Point to Point Layer 2 Services Commands
neighbor (L2VPN)