Cisco ASR 9000 Series Reference Guide

mvrp static
To enable Multiple VLAN Registration Protocol (MVRP) in static mode and to enter the MVRP configuration
submode, use the mvrp static command in the MSTP configuration mode. To return to the default setting,
use the no form of this command.
mvrp static
no mvrp static
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
MSTP configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to enable MVRP static mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# spanning-tree mst AA
RP/0/RSP0/CPU0:router(config-mstp)# mvrp static
RP/0/RSP0/CPU0:router(config-mvrp)#
Related Commands
DescriptionCommand
Enables debugging of sent and received MVRP packets.debug ethernet mvrp packets, on page 475
Enables MVRP protocol debugging on a specific interface,
location or vlan.
debug ethernet mvrp protocol, on page 477
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
546
Multiple Spanning Tree Protocol Commands
mvrp static

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model