Cisco ASR 9000 Series - Generic-Interface-List

To Next Page

To Previous Page

generic-interface-list

To configure generic interface list, use the generic-interface-list command in global configuration mode.

generic-interface-list list-name

Syntax Description

Name of the interface list.

list-name

Command Default

None

Command Modes

Global configuration

Command History

ModificationRelease

This command was introduced.Release 4.2.1

Usage Guidelines

To use this command, you must be in a user group associated with a task group that includes appropriate task

IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator

for assistance.

Task ID

OperationTask ID

read, writel2vpn

Examples

This example shows how to configure generic interface list:

RP/0/RSP0/CPU0:router# config

RP/0/RSP0/CPU0:router(config)# generic-interface-list interfacelist1

RP/0/RSP0/CPU0:router(config-if-list)# interface GigabitEthernet 0/2/0/1

RP/0/RSP0/CPU0:router(config-if-list)# interface GigabitEthernet 0/3/0/1

RP/0/RSP0/CPU0:router(config-if-list)# exit

Related Commands

DescriptionCommand

Displays all the L2VPN virtual interfaces.show l2vpn generic-interface-list, on page 185

Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release

6.1.x

Point to Point Layer 2 Services Commands

generic-interface-list

Other manuals for Cisco ASR 9000 Series