Cisco ASR 9000 Series - Point to Point Layer 2 Services Commands

Point to Point Layer 2 Services Commands
This module describes the commands used to configure, monitor, and troubleshoot a Layer 2 or Layer 3
virtual private network (VPN).
For detailed information about virtual private network concepts, configuration tasks, and examples, refer to
the Cisco ASR 9000 Series Aggregation Services Router L2VPN and Ethernet Services Configuration Guide.
•
address-family l2vpn mspw, page 64
•
bgp, page 65
•
backup (L2VPN), page 66
•
backup disable (L2VPN), page 68
•
clear l2vpn collaborators, page 70
•
clear l2vpn counters bridge mac-withdrawal, page 71
•
clear l2vpn forwarding counters, page 72
•
clear l2vpn forwarding counters bridge-domain mirp-lite, page 73
•
clear l2vpn forwarding message counters, page 74
•
clear l2vpn forwarding table, page 75
•
control-word, page 76
•
dynamic-arp-inspection, page 77
•
flood mode, page 79
•
generic-interface-list, page 81
•
global-id (L2VPN), page 82
•
interface (p2p), page 83
•
interworking ipv4, page 85
•
ipv4 source, page 86
•
l2tp static, page 87
•
ip-source-guard, page 90
•
l2transport, page 92
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
61