Cisco ASR 9000 Series Reference Guide

evi
To enter the EVPN EVI configuration mode and configure optional BGP settings for a bridge domain or EVI,
use the evi command in the EVPN configuration mode. To return to the EVPN configuration mode, use the
no form of this command.
evi evi-id
no evi evi-id
Syntax Description
Specifies the Ethernet VPN ID to set. The range is from 1 to 65534.
evi-id
Command Default
None.
Command Modes
EVPN configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use this command to configure static BGP route distinguisher or BGP route target for an EVI.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to enter the EVPN EVI configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# evi 2
RP/0/RSP0/CPU0:router(config-evpn-evi)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
398
Provider Backbone Bridge Commands
evi

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model