debug spanning-tree repag packet
To enable Resilient Ethernet Protocol (REP) Access Gateway debugging commands, use the debug
spanning-tree repag packet command in the EXEC mode. To disable debugging, use the no form of this
command.
debug spanning-tree repag packet {brief| full} {sent| received} [interface interface-name]
no debug spanning-tree repag packet {brief| full} {sent| received} [interface interface-name]
Syntax Description
Enables brief debugging output.brief
Enables full debugging output.full
Display packets being received.received
Display packets being sent.sent
{Optional} Filters by interface.
Physical interface or a virtual interface.
Use the show interfaces command to see a list of all possible interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface interface-name
Command Default
If an interface is not specified, then debug is enabled for all interfaces.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readinterface
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
493
Multiple Spanning Tree Protocol Commands
debug spanning-tree repag packet
To Next Page
Loading...
Need help?
General
