signaling-protocol
To enable signaling for the VFI, use the signaling-protocol command in the BGP autodiscovery mode or in
the L2VPN bridge group bridge domain VFI multicast P2MP configuration mode. To return to the default
value, use the no form of this command.
signaling-protocol {bgp| ldp}
no signaling-protocol {bgp| ldp}
Syntax Description
Enables BGP protocol signaling.bgp
Enables LDP protocol signaling.ldp
Command Default
LDP signaling is enabled.
Command Modes
BGP autodiscovery configuration
L2VPN bridge group bridge domain VFI multicast P2MP configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Support for this command in the L2VPN bridge group bridge domain VFI
multicast P2MP configuration mode was introduced.
Release 5.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Examples
This example shows how to enable signaling for BGP protocol:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group EGroup
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
365
Multipoint Layer 2 Services Commands
signaling-protocol
To Next Page
Loading...
Need help?
General
