Cisco ASR 9000 Series Reference Guide

RP/0/RSP0/CPU0:router(config-if)# dot1q tunneling ethertype 0x9100
RP/0/RSP0/CPU0:router(config-if)#
The following example shows how to configure the Ethertype to 0x9200:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/1/5/1
RP/0/RSP0/CPU0:router(config-if)# dot1q tunneling ethertype 0x9200
RP/0/RSP0/CPU0:router(config-if)#
Related Commands
DescriptionCommand
Defines the matching criteria to map 802.1Q frames ingress on an
interface to the appropriate service instance.
encapsulation dot1q, on page 8
Defines the matching criteria to be used in order to map single-tagged
802.1ad frames ingress on an interface to the appropriate service
instance.
encapsulation dot1ad dot1q, on page
6
Defines the matching criteria to map Q-in-Q ingress frames on an
interface to the appropriate service instance.
encapsulation dot1q second-dot1q, on
page 10
Defines the matching criteria to map untagged ingress Ethernet frames
on an interface to the appropriate service instance.
encapsulation untagged, on page 12
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
3
Ethernet Interfaces Commands
dot1q tunneling ethertype

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model