Cisco ASR 9000 Series - Page 189

bytes: received 0, sent 0
Segment 2
MPLS, Destination address: 101.101.101.101, pw-id: 1000, status: Bound
Pseudowire label: 16000
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
Backup PW
MPLS, Destination address: 102.102.102.102, pw-id: 1000, status: Bound
Pseudowire label: 16001
Statistics:
packets: received 0, sent 0
bytes: received 0, sent 0
RP/0/RSP0/CPU0:router#show l2vpn forwarding bridge-domain detail location 0/2/CPU0
Bridge-domain name: bg1:bd1, id: 0, state: up
….
GigabitEthernet0/2/0/0.4, state: oper up
RG-ID 1, active
Number of MAC: 0
…..
Nbor 101.101.101.101 pw-id 5000
Backup Nbor 101.101.101.101 pw-id 5000
Number of MAC: 0
….
RP/0/RSP0/CPU0:router#show l2vpn forwarding bridge-domain detail location 0/2/CPU0
Bridge-domain name: bg1:bd1, id: 0, state: up
….
GigabitEthernet0/2/0/0.4, state: oper up
XC ID: 0x1880002
Number of MAC: 0
Statistics:
packets: received 0 (multicast 0, broadcast 0, unknown unicast 0, unicast 0), sent 963770
bytes: received 0 (multicast 0, broadcast 0, unknown unicast 0, unicast 0), sent 263433178
MAC move: 0
Storm control drop counters:
packets: broadcast 0, multicast 0, unknown unicast 0
bytes: broadcast 0, multicast 0, unknown unicast 0
Dynamic arp inspection drop counters:
packets: 0, bytes: 0
IP source guard drop counters:
packets: 0, bytes: 0
….
The following sample outputs displays the SPAN segment information of the xconnect:
RP/0/RSP0/CPU0:router# show l2vpn forwarding counter location 0/7/CPU0
Legend: ST = State, DN = Down
Segment 1 Segment 2 ST Byte
Switched
----------------------------- ----------------------- -- ---------
pw-span-test (Monitor-Session) mpls 2.2.2.2 UP 0
RP/0/RSP0/CPU0:router #Show l2vpn forwarding monitor-session location 0/7/CPU0
Segment 1 Segment 2 State
------------------------------------ ------------------------------------ ------
pw-span-test(monitor-session) mpls 2.2.2.2 UP
pw-span-sess(monitor-session) mpls 3.3.3.3 UP
RP/0/RSP0/CPU0:router #Show l2vpn forwarding monitor-session pw-span-test location 0/7/CPU0
Segment 1 Segment 2 State
------------------------------------ ------------------------------------ ------
pw-span-test(Monitor-Session) mpls 2.2.2.2 UP
Example 4:
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
175
Point to Point Layer 2 Services Commands
show l2vpn forwarding