(Optional) Filters the following xconnect types:
•
ac-pw
•
locally switched
•
monitor-session-pw
•
ms-pw
type
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.7.2
The following keywords were introduced:
•
location
•
standby
Release 4.3.0
This command was modified to enable filtering the command output for
a specific pseudowire with just the pseudowire ID.
Release 5.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If a specific cross-connect is specified in the command (for instance, AC_to_PW1) then only that cross-connect
will be displayed; otherwise, all cross-connects are displayed.
When configuring Ethernet Connectivity Fault Managment (CFM) over l2vpn cross-connect, the CFM
Continuity Check Messages (CCM) packets are not accounted for in the cross-connect pseudowire packet
counters displayed in this show command output.
For Cisco IOS XR software Release 5.1.2 and above, you can filter the command output for specific
pseudowire with just the pseudowire ID. However, for pseudowire configurations with FEC 129 Type 2
(in VPWS), filtering the output for a specific pseudowire can only be done with the combination of the
neighbour filter and the pseudowire ID.
Note
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
204
Point to Point Layer 2 Services Commands
show l2vpn xconnect
To Next Page
Loading...
Need help?
General
