Cisco ASR 9000 Series Reference Guide

RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# mac
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac)# limit
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac-limit)# maximum 5000
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac-limit)# action no-flood
Related Commands
DescriptionCommand
Configures bridge behavior when the number of learned MAC
addresses reaches the MAC limit configured.
action (VPLS), on page 232
Establishes a bridge domain, and enters L2VPN bridge group bridge
domain configuration mode.
bridge-domain (VPLS), on page 240
Creates a bridge group so that it can contain bridge domains and then
to assign network interfaces to the bridge domain.
bridge group (VPLS), on page 242
Enters L2VPN configuration mode.l2vpn, on page 100
Sets the MAC address limit for action, maximum, and notification
and enters L2VPN bridge group bridge domain MAC limit
configuration mode.
limit (VPLS), on page 275
Enters L2VPN bridge group bridge domain MAC configuration mode.mac (VPLS), on page 277
Specifies the type of notification that is sent when the number of
learned MAC addresses exceeds the configured limit.
notification (VPLS), on page 295
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
282
Multipoint Layer 2 Services Commands
maximum (VPLS)

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model