Cisco ASR 9000 Series - Page 328

Examples
This example shows how to assign port0 as neighbor:
RP/0/RSP0/CPU0:router#configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# ethernet ring g8032 r1
RP/0/RSP0/CPU0:router(config-l2vpn-erp)# instance 1
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance)# description test
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance)# profile p1
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance)# rpl port0 neighbor
RP/0/RSP0/CPU0:router(config-l2vpn-erp-instance)#
Related Commands
DescriptionCommand
Enters L2VPN configuration mode.l2vpn, on page 100
Enables G.8032 ring mode and enters the G.8032 configuration
submode.
ethernet ring g8032, on page 251
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
314
Multipoint Layer 2 Services Commands
rpl