Cisco ASR 9000 Series - Page 404

This example shows how to enable BGP in the EVPN EVI configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# evi 2
RP/0/RSP0/CPU0:router(config-evpn-evi)# bgp
RP/0/RSP0/CPU0:router(config-evpn-evi-bgp)#
Related Commands
DescriptionCommand
Enters EVPN configuration mode.evpn, on page 400
Enters the EVPN EVI configuration mode to configure optional BGP
settings for a bridge domain or EVI.
evi, on page 398
Specifies a route target for the VFI, PBB EVPN or EVPN bridge
domain.
route-target, on page 308
rd
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
390
Provider Backbone Bridge Commands
bgp (EVPN)