Cisco ASR 9000 Series - Page 425

•
module: Module number. A physical layer interface module (PLIM) is always 0.
•
port: Physical port number of the interface.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to enter the EVPN Interface configuration mode for bundle-ether 1:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# interface bundle-ether 1
RP/0/RSP0/CPU0:router(config-evpn-ac)#
Related Commands
DescriptionCommand
Enters EVPN configuration mode.evpn, on page 400
Enters EVPN interface ethernet segment configuration mode.ethernet-segment, on page 396
Performs a MAC flush on an Ethernet-segment.mac-flush mvrp, on page 418
Configures timers that affect the convergence of PBB EVPN in
failure scenarios.
timers, on page 458
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
411
Provider Backbone Bridge Commands
interface (EVPN)