Cisco ASR 9000 Series - Page 636

Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readinterface
Examples
The following example shows the output from the show spanning-tree repag topology-change flushes
command, which displays details on the MSTIs :
RP/0/RSP0/CPU0:router#show spanning-tree repag b topology-change flushes
MSTAG Protocol Instance b
Interface Last TC Reason Count
------------ ------------------- -------------------------------- -----
Gi0/0/0/1 18:03:24 2009-07-14 Gi0/0/0/1.10 egress TCN 65535
Gi0/0/0/2 21:05:04 2009-07-15 Gi0/0/0/2.1234567890 ingress TCN 2
Related Commands
DescriptionCommand
Enables Resilient Ethernet Protocol (REP) Access Gateway
debugging commands.
debug spanning-tree repag packet, on page
493
Displays the values currently used for populating the BPDUs
sent by all ports.
show spanning-tree repag, on page 617
Displays BPDU information from root (bridge ID, cost, and
priority) and the BPDU information being sent on the port.
show spanning-tree repag bpdu interface,
on page 619
Enters the Resilient Ethernet Protocol Access Gateway (REPAG)
configuration submode.
spanning-tree repag, on page 633
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
622
Multiple Spanning Tree Protocol Commands
show spanning-tree repag topology-change flushes