Cisco ASR 9000 Series Reference Guide

Examples
The following example shows how to enable fragmentation over an interface tunnel.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface tunnel-ip 400
RP/0/RSP0/CPU0:router(config-if)# tunnel dfbit disable
Related Commands
DescriptionCommand
Specifies a tunnel interface's destination address.tunnel destination, on page 43
Configures the encapsulation mode of the tunnel interface.tunnel mode, on page 51
Sets a tunnel interface's source address.tunnel source, on page 53
Specifies the value of the TOS field in the tunnel encapsulating
packets.
tunnel tos, on page 55
Configures the Time-To-Live (TTL) for packets entering the
tunnel.
tunnel ttl, on page 57
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
50
Generic Routing Encapsulation Commands
tunnel dfbit

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model