D-Link DES-3010GA - ip igmp snooping leave-time-out

D-Link DES-3010FA/GA CLI Reference Guide
Page 109
ip igmp snooping mrouter-time-out
The ip igmp snooping mrouter-time-out Interface Configuration (VLAN) mode command configures the
mrouter-time-out. The ip igmp snooping mrouter-time-out Interface Configuration (VLAN) mode command is
used for setting the aging-out time after multicast router ports are automatically learned. To return to the default
configuration, use the no form of this command.
Syntax
ip igmp snooping mrouter-time-out time-out
no ip igmp snooping mrouter-time-out
Parameters
•
time-out — Multicast router timeout in seconds (Range: 1 - 2147483647)
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the multicast router timeout to 200 seconds.
Console(config)# interface vlan 2
Console(config-if)#
ip igmp snooping mrouter-time-out 200