D-Link DES-3010GA - show fiber-ports optical-transceiver

D-Link DES-3010FA/GA CLI Reference Guide
Page 151
show copper-ports cable-length
The show copper-ports cable-length User EXEC mode command displays the estimated copper cable length
attached to a port.
Syntax
show copper-ports cable-length [interface]
Parameters
•
interface — A valid Ethernet port. (Full syntax: port)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
The port must be active and working in 100M or 1000M mode.
Example
The following example displays the estimated copper cable length attached to all ports.
Console> show copper-ports cable-length
Port Length [meters]
---- ---------------------
1< 50
2 Copper not active
3 110-140
10 Fiber