D-Link DES-3010GA - duplex

Ethernet Configuration Commands
Page 76
speed
The speed Interface Configuration (Ethernet, port-channel) mode command configures the speed of a given
Ethernet interface when not using auto-negotiation. To restore the default configuration, use the no form of this
command.
Syntax
speed {10 | 100 | 1000 |}
no speed
Parameters
•
10 — Forces10 Mbps operation.
• 100 — Forces 100 Mbps operation.
• 1000 — Forces 1000 Mbps operation.
Default Configuration
Maximum port capability
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The no speed command in a port-channel context returns each port in the port-channel to its maximum capability.
Example
The following example configures the speed operation of Ethernet port 5 to 100 Mbps operation.
Console(config)# interface ethernet 5
Console(config-if)#
speed 100