D-Link DES-3010GA - lacp timeout

D-Link DES-3010FA/GA CLI Reference Guide
Page 129
lacp port-priority
The lacp port-priority Interface Configuration (Ethernet) mode command configures physical port priority. To
return to the default configuration, use the no form of this command.
Syntax
lacp port-priority value
no lacp port-priority
Parameters
•
value — Specifies port priority. (Range: 1 - 65535)
Default Configuration
The default port priority is 1.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example defines the priority of Ethernet port 6 as 247.
Console(config)# interface ethernet 6
Console(config-if)#
lacp port-priority 247