D-Link DES-3010GA - Show Bridge Multicast Filtering

Address Table Commands
Page 44
show bridge multicast filtering
The show bridge multicast filtering User EXEC mode command displays the multicast filtering configuration.
Syntax
show bridge multicast filtering vlan-id
Parameters
•
vlan-id — VLAN ID value.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, the multicast configuration for VLAN 1 is displayed.
Console# show bridge multicast filtering 1
Filtering: Enabled
VLAN: 1
Port Forward-Unregistered Forward-All
Static Status Static Status
---- --------- --------- --------- ----------
1 Forbidden Filter Forbidden Filter
2 Forward Forward(s) Forward Forward(s)
3 - Forward(d) - Forward(d)