SNMP Commands
Page 212
snmp-server set
The snmp-server set Global Configuration mode command defines the SNMP MIB value.
Syntax
snmp-server set variable-name name1 value1 [ name2 value2 …]
Parameters
•
variable-name — MIB variable name.
• name value — List of name and value pairs. In the case of scalar MIBs, only a single pair of name values. In
the case of an entry in a table, at least one pair of name and value followed by one or more fields.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Although the CLI can set any required configuration, there might be a situation where a SNMP user sets a MIB
variable that does not have an equivalent command. In order to generate configuration files that support those sit-
uations, the snmp-server set command is used.
This command is case-sensitive.
To Next Page
Loading...
Need help?
General