QoS Commands
Page 170
qos trust (Interface)
The qos trust Interface Configuration (Ethernet, port-channel) mode command enables each port trust state while
the system is in the basic QoS mode. To disable the trust state on each port, use the no form of this command.
Syntax
qos trust
no qos trust
Default Configuration
qos trust is enabled on each port.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures Ethernet port 4 to the default trust state.
console(config)#
interface ethernet
4
console(config-if) qos trust
To Next Page
Loading...
