Ethernet Configuration Commands
Page 86
show interfaces configuration
The show interfaces configuration Privileged EXEC mode command displays the configuration for all config-
ured interfaces.
Syntax
show interfaces configuration [ethernet interface | port-channel port-channel-number ]
Parameters
•
interface — Valid Ethernet port. (Full syntax: port)
• port-channel-number — Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the configuration of all configured interfaces:
Console#
show interfaces configuration
Port Type Duplex Speed Neg Flow
Ctrl
Link
State
Back
Pressure
Mdix
Mode
---- ----------- ------ ----- ------- ---- ----- -------- ----
1 100M-Copper Full 100 Enabled Off Up Disabled Auto
2 100M-Copper Full 100 Enabled Off Up Disabled Auto
3 100M-Copper Full 100 Enabled Off Up Disabled Auto
4 100M-Copper Full 100 Enabled Off Up Disabled Auto
5 100M-Copper Full 100 Enabled Off Up Disabled Auto
6 100M-Copper Full 100 Enabled Off Up Disabled Auto
7 100M-Copper Full 100 Enabled Off Up Disabled Auto
8 100M-Copper Full 100 Enabled Off Up Disabled Auto
9 1G-Copper Full 1000 Enabled Off Up Disabled Auto
10 100M-Fiber Full 100 Enabled Off Up Disabled Auto
To Next Page
Loading...
Need help?
General