GVRP Commands
Page 98
gvrp enable (Interface)
The gvrp enable Interface Configuration (Ethernet, port-channel) mode command enables GVRP on an interface.
To disable GVRP on an interface, use the no form of this command.
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
An access port does not dynamically join a VLAN because it is always a member in only one VLAN.
Membership in an untagged VLAN is propagated in the same way as in a tagged VLAN. That is, the PVID is man-
ually defined as the untagged VLAN VID.
Example
The following example enables GVRP on Ethernet port 6.
Console(config)#
interface ethernet
6
Console(config-if)#
gvrp enable
To Next Page
Loading...
