D-Link DES-3010GA User Manual

D-Link DES-3010FA/GA CLI Reference Guide
Page 249
Section 21.Syslog Commands
logging on
The logging on Global Configuration mode command controls error message logging. This command sends
debug or error messages to a logging process, which logs messages to designated locations asynchronously to
the process that generated the messages. To disable the logging process, use the no form of this command.
Syntax
logging on
no logging on
Default Configuration
Logging is enabled.
Command Mode
Global Configuration mode
User Guidelines
The logging process controls the distribution of logging messages at various destinations, such as the logging
buffer, logging file or syslog server. Logging on and off at these destinations can be individually configured using
the logging buffered, logging file, and logging Global Configuration mode commands. However, if the logging
on command is disabled, no messages are sent to these destinations. Only the console receives messages.
Example
The following example enables logging error messages.
Console(config)# logging on

D-Link DES-3010GA Specifications

General

Brand	D-Link
Model	DES-3010GA
Category	Switch
Language	English