D-Link DES-3010GA - Syslog Commands; logging on

Spanning-Tree Commands
Page 248
Console# show spanning-tree
Spanning tree disabled (BPDU flooding) mode STP
Default port cost method: short
Root ID Priority 32768
Address 00:19:28:37:46:00
This switch is the root
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Number of topology changes 0 last change occurred 00:01:07 ago
Times: hold 1, topology change 35, notification 2
hello 2, max age 20, forward delay 15
Interfaces
Name State Prio.Nbr Cost Sts Role PortFast Type
------ -------- -------- --------- ------ ---- -------- --------------
1 enabled 128.1 19 DSBL Desg No P2p (STP)
2 enabled 128.2 19 DSBL Desg No P2p (STP)
3 enabled 128.3 19 DSBL Desg No P2p (STP)
4 enabled 128.4 19 DSBL Desg No P2p (STP)
5 enabled 128.5 100 DSBL Desg No P2p (STP)
6 enabled 128.6 100 DSBL Desg No P2p (STP)
7 enabled 128.7 100 DSBL Desg No P2p (STP)
8 enabled 128.8 19 DSBL Desg No P2p (STP)
9 enabled 128.9 4 DSBL Desg No P2p (STP)
10 enabled 128.10 100 DSBL Desg No P2p (STP)
ch1 enabled 128.1000 4 DSBL Desg No P2p (STP)
ch2 enabled 128.1001 4 DSBL Desg No P2p (STP)
ch3 enabled 128.1002 4 DSBL Desg No P2p (STP)
ch4 enabled 128.1003 4 DSBL Desg No P2p (STP)
ch5 enabled 128.1004 4 DSBL Desg No P2p (STP)
ch6 enabled 128.1005 4 DSBL Desg No P2p (STP)
ch7 enabled 128.1006 4 DSBL Desg No P2p (STP)
ch8 enabled 128.1007 4 DSBL Desg No P2p (STP)
console#