D-Link DES-3010GA User Manual

D-Link DES-3010FA/GA CLI Reference Guide
Page 167
wrr-queue cos-map
The wrr-queue cos-map Global Configuration mode command maps Class of Service (CoS) values to a specific
egress queue. To return to the default configuration, use the no form of this command.
Syntax
wrr-queue cos-map queue-id cos1...cos8
no wrr-queue cos-map [queue-id]
Parameters
•
queue-id — Specifies the queue number to which the CoS values are mapped.
• cos1...cos8 — Specifies CoS values to be mapped to a specific queue. (Range: 0-7)
Default Configuration
The map default values for 4 queues:
• CoS value 1 select queue 1
• CoS value 2 select queue 1
• CoS value 0 select queue 2
• CoS value 3 select queue 2
• CoS value 4 select queue 3
• CoS value 5 select queue 3
• CoS value 6 select queue 4
• CoS value 7 select queue 4
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example maps CoS 7 to queue 2.
Console(config)# wrr-queue cos-map 2 7

D-Link DES-3010GA Specifications

General

Brand	D-Link
Model	DES-3010GA
Category	Switch
Language	English