D-Link DES-3010GA - switchport general acceptable-frame-type tagged-only

VLAN Commands
Page 302
switchport general ingress-filtering disable
The switchport general ingress-filtering disable Interface Configuration mode command disables port ingress
filtering. To return to the default configuration, use the no form of this command.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example disables port ingress filtering on Ethernet port 6.
Console(config)# interface ethernet 6
Console(config-if)# switchport general ingress-filtering disable