D-Link DES-3010GA - enable authentication

D-Link DES-3010FA/GA CLI Reference Guide
Page 21
login authentication
The login authentication Line Configuration mode command specifies the login authentication method list for a
remote telnet or console. To return to the default configuration specified by the aaa authentication login com-
mand, use the no form of this command.
Syntax
login authentication {default | list-name}
no login authentication
Parameters
•
default — Uses the default list created with the aaa authentication login command.
• list-name — Uses the indicated list created with the aaa authentication login command.
Default Configuration
Uses the default set with the command aaa authentication login.
Command Mode
Line Configuration mode
User Guidelines
Changing login authentication from default to another value may disconnect the telnet session.
Example
The following example specifies the default authentication method for a console.
Console(config)# line console
Console(config-line)# login authentication default