LACP Commands
Page 130
lacp timeout
The lacp timeout Interface Configuration (Ethernet) mode command assigns an administrative LACP timeout. To
return to the default configuration, use the no form of this command.
Syntax
lacp timeout {long | short}
no lacp timeout
Parameters
•
long — Specifies the long timeout value.
• short — Specifies the short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example assigns a long administrative LACP timeout to Ethernet port 6 .
Console(config)#
interface ethernet
6
Console(config-if)#
lacp timeout long
To Next Page
Loading...
