D-Link DES-3010GA - GVRP Commands; gvrp enable (Global)

Ethernet Configuration Commands
Page 96
show ports storm-control
The show ports storm-control Privileged EXEC mode command displays the storm control configuration.
Syntax
show ports storm-control [interface]
Parameters
•
interface — A valid Ethernet port. (Full syntax: port)
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the storm control configuration.
Console# show ports storm-control
Port State Rate [Kbits/Sec] Included
---- -------- ---------------- --------------------------------------
1 Enabled 100 Broadcast
2 Enabled 100 Broadcast
3 Enabled 100 Broadcast
4 Enabled 100 Broadcast
5 Enabled 100 Broadcast
6 Enabled 100 Broadcast
7 Enabled 100 Broadcast
8 Enabled 100 Broadcast
9 Enabled 1000 Broadcast
10 Disabled 1000 Broadcast