D-Link DES-3010GA - switchport general ingress-filtering disable

D-Link DES-3010FA/GA CLI Reference Guide
Page 301
switchport general pvid
The switchport general pvid Interface Configuration mode command configures the PVID when the interface is
in general mode. To return to the default configuration, use the no form of this command.
Syntax
switchport general pvid vlan-id
no switchport general pvid
Parameters
•
vlan-id — Specifies the PVID (Port VLAN ID).
Default Configuration
If the default VLAN is enabled, PVID = 1. Otherwise, PVID=4095.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the PVID for Ethernet port 6, when the interface is in general mode.
Console(config)# interface ethernet 6
Console(config-if)# switchport general pvid 234