Radius Commands
Page 178
radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval during which the device waits
for a server host to reply. To return to the default configuration, use the no form of this command.
Syntax
radius-server timeout timeout
no radius-server timeout
Parameters
•
timeout — Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The timeout value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the timeout interval to 5 seconds.
Console(config)# radius-server timeout 5
To Next Page
Loading...
Need help?
General