D-Link DES-3010GA User Manual

D-Link DES-3010FA/GA CLI Reference Guide
Page 327
dot1x timeout server-timeout
The dot1x timeout server-timeout Interface Configuration mode command sets the time that the device waits for
a response from the authentication server. To return to the default configuration, use the no form of this command.
Syntax
dot1x timeout server-timeout seconds
no dot1x timeout server-timeout
Parameters
•
seconds — Time in seconds that the device waits for a response from the authentication server.
(Range: 1-65535 seconds)
Default Configuration
The timeout period is 30 seconds.
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
The actual timeout can be determined by comparing the dot1x timeout server-timeout value and the result of
multiplying the radius-server retransmit value with the radius-server timeout value and selecting the lower of
the two values.
Examples
The following example sets the time for the retransmission of packets to the authentication server to 3600 sec-
onds.
Console(config-if)# dot1x timeout server-timeout 3600

D-Link DES-3010GA Specifications

General

Brand	D-Link
Model	DES-3010GA
Category	Switch
Language	English