D-Link DES-3010GA - show qos interface

D-Link DES-3010FA/GA CLI Reference Guide
Page 163
rate-limit interface configuration
The rate-limit interface configuration command limits the rate of the incoming traffic. The no form of this com-
mand is used to disable rate limit.
Syntax
rate-limit rate
no rate-limit
Parameters
•
kbps Maximum of kilobits per second of ingress traffic on a port. (Range: 62K - 100M)
Defaults
1000 Kbits/Sec
Command Modes
Interface configuration (Ethernet)
Usage Guidelines
The command can be enabled on a specific port only if port storm-control brodcast enable interface configura-
tion command is not enabled on that port.
Examples
The following example limits the rate of the incoming traffic to 62.
Console(config-ip)# rate-limit 62