D-Link DES-3010GA User Manual

Address Table Commands
Page 30
bridge multicast filtering
The bridge multicast filtering Global Configuration mode command enables filtering multicast addresses. To dis-
able filtering multicast addresses, use the no form of this command.
Syntax
bridge multicast filtering
no bridge multicast filtering
Default Configuration
Filtering multicast addresses is disabled. All multicast addresses are flooded to all ports.
Command Mode
Global Configuration mode
User Guidelines
If multicast routers exist on the VLAN, do not change the unregistered multicast addresses state to drop on the
switch ports.
If multicast routers exist on the VLAN and IGMP-snooping is not enabled, the bridge multicast forward-all com-
mand should be used to enable forwarding all multicast packets to the multicast switches.
Example
In this example, bridge multicast filtering is enabled.
Console(config)# bridge multicast filtering

D-Link DES-3010GA Specifications

General

Brand	D-Link
Model	DES-3010GA
Category	Switch
Language	English