VLAN Commands
Page 298
switchport trunk allowed vlan
The switchport trunk allowed vlan Interface Configuration mode command adds or removes VLANs to or from a
trunk port.
Syntax
switchport trunk allowed vlan {add vlan-list | remove vlan-list }
Parameters
•
add vlan-list — List of VLAN IDs to be added. Separate nonconsecutive VLAN IDs with a comma and no
spaces. A hyphen designates a range of IDs.
• remove vlan-list — List of VLAN IDs to be removed. Separate nonconsecutive VLAN IDs with a comma and
no spaces. A hyphen designates a range of IDs.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example adds VLANs 1, 2, 5 to 6 to the allowed list of Ethernet port 6.
Console(config)# interface ethernet 6
console(config-if)# switchport trunk allowed vlan add 1-2,5-6
To Next Page
Loading...
