D-Link DES-3010GA - Show Interfaces Counters

Ethernet Configuration Commands
Page 90
show interfaces counters
The show interfaces counters User EXEC mode command displays traffic seen by the physical interface.
Syntax
show interfaces counters [ethernet interface | port-channel port-channel-number]
Parameters
•
interface — A valid Ethernet port. (Full syntax: port)
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Modes
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Examples
The following example displays traffic seen by the physical interface:
Console# show interfaces counters
Port InOctets InUcastPkts InMcastPkts InBcastPkts
---- -------- ----------- ----------- -----------
1 183892 0 0 0
20 0 0 0
3 123899 0 0 0
40 0 0 0
50 0 0 0
60 0 0 0
7 9188 0 0 0
80 0 0 0
9 8789 0 0 0
10 0 0 0 0
Ch OutOctets OutUcastPkts OutMcastPkts OutBcastPkts
--- --------- ------------ ------------ ------------
10 0 0 0
2 27889 0 0 0