D-Link DES-3010GA User Manual

Spanning-Tree Commands
Page 236
spanning-tree mst priority
The spanning-tree mst priority Global Configuration mode command configures the device priority for the spec-
ified spanning-tree instance. To return to the default configuration, use the no form of this command.
Syntax
spanning-tree mst instance-id priority priority
no spanning-tree mst instance-id priority
Parameters
•
instance -id—ID of the spanning -tree instance (Range: 1-16).
• priority—Device priority for the specified spanning-tree instance (Range: 0-61440 in multiples of 4096).
Default Configuration
The default bridge priority for IEEE Spanning Tree Protocol (STP) is 32768.
Command Mode
Global Configuration mode
User Guidelines
The device with the lowest priority is selected as the root of the spanning tree.
Example
The following example configures the spanning tree priority of instance 1 to 4096.
Console (config) # spanning-tree mst 1 priority 4096

D-Link DES-3010GA Specifications

General

Brand	D-Link
Model	DES-3010GA
Category	Switch
Language	English