D-Link DES-3010GA User Manual

D-Link DES-3010FA/GA CLI Reference Guide
Page 229
spanning-tree port-priority
The spanning-tree port-priority Interface Configuration mode command configures port priority. To return to the
default configuration, use the no form of this command.
Syntax
spanning-tree port-priority priority
no spanning-tree port-priority
Parameters
•
priority — The priority of the port. (Range: 0 - 240 in multiples of 16). Allowed values are :0 16 32 48 64 80
96 112 128 144 160 176 192 208 224 240
Default Configuration
The default port priority for IEEE Spanning TreeProtocol (STP) is 128.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the spanning priority on Ethernet port 3 to 16.
Console(config)# interface ethernet 3
Console(config-if)# spanning-tree port-priority 16

D-Link DES-3010GA Specifications

General

Brand	D-Link
Model	DES-3010GA
Category	Switch
Language	English