D-Link DES-3528 - xStack Switch - Stackable - Page 131

xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide
VID
Enter the VID value used.
Remap Priority
e is specified, the packet’s original priority will be used.
The user can select this option to enable the Remap Priority feature.
Specify the remap priority (0 to 7) to be associated with the data traffic to be forwarded
on the multicast VLAN. If Non
The default setting is None.
Replace Priority
effect when the remap priority is set.
Tick the check box to specify that the packet’s priority will be changed by the Switch,
based on the remap priority. This flag will only take
Click the Apply button to accept the changes made for each individual section.
Multicast VLAN Settings for the specific entry.
lick the Profile List
Click the Add button to add a new entry based on the information entered.
Click the Edit button to configure the MLD Snooping
Click the Delete button to remove the specific entry.
C
link to configure the MLD Snooping Multicast VLAN Settings for the specific entry.
After clicking the Edit button, the following page will appear:
Figure 4-73 MLD Snooping Multicast VLAN Settings – Edit window
The fields that can be configur ed below: ed are describ
Parameter Description
VLAN Name
igured. This option will display the VLAN name of the VLAN conf
State
Use the drop-down menu to enable or disable the state.
Replace Source IP
s
y this IP address. If none is specified, the
With the MLD snooping function, the MLD report packet sent by the host will be
forwarded to the source port. Before forwarding of the packet, the source IP addres
in the join packet needs to be replaced b
source IP address will not be replaced.
Remap Priority
If None is specified, the packet’s original priority is used. The default setting is
0-7 – The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
None –
None.
Replace Priority
d on the remap priority. This flag will only take effect when the remap priority is
Tick the check box to specify that the packet’s priority will be changed by the Switch,
base
set.
122