xStack® DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch Web UI Reference Guide
From Port
The beginning port of a consecutive group of ports to be configured.
To Port
The ending port of a consecutive group of ports to be configured.
Admin State
Use the pull-down menu to enable or disable Port Security (locked MAC address table
for the selected ports).
Lock Address Mode
This pull-down menu allows the option of how the MAC address table locking will be
implemented on the Switch, for the selected group of ports. The options are:
Permanent – The locked addresses will only age out after the Switch has been reset.
DeleteOnTimeout – The locked addresses will age out after the aging timer expires.
DeleteOnReset – The locked addresses will not age out until the Switch has been reset
or rebooted.
Max Learning Address
Specify the maximum value of port security entries that can be learned on this port.
Click the Apply button to accept the changes made for each individual section.
Click the Edit button to re-configure the specific entry.
Click the View Details button to display the information of the specific entry.
After clicking the View Details button, the following page will appear:
Figure 8-50 Port Security Port-VLAN Settings window
See the next section for parameter descriptions.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
Port Security VLAN Settings
Users can configure the maximum number of port-security entries that can be learned on a specific VLAN.
To view this window, click Security > Port Security > Port Security VLAN Settings, as shown below:
Figure 8-51 Port Security VLAN Settings window
The fields that can be configured are described below:
248
To Next Page
Loading...
