Dasan V8102 - Network Service Module (NSM) Daemon Debugging; Network Service Module (NSM) Informtaion

User Manual UMN:CLI
V8102
143
6.2.18 Network Service Module (NSM) Informtaion
To display the information of the NSM Client, use the following command.
Command
Mode
Description
show nsm client
Enable
Global
Shows the information of the NSM client.
6.2.19 Network Service Module (NSM) Daemon Debugging
To enable NSM daemon debugging, use the following command.
Command
Mode
Description
debug nsm [all]
Enable
Global
Enables NSM debugging.
all: all NSM debugging
debug nsm ha [all]
Enables NSM high availability debugging.
debug nsm {events | kernel}
Enable
Enables NSM events/kernel debugging.
debug nsm packet {send | recv}
[detail]
Enables NSM packets debugging.
packet: NSM packets
send: outgoing packets
recv: incoming packets
detail: detailed information
debug nsm packet [detail]
To disable NSM debugging, use the following command.
Command
Mode
Description
no debug nsm [all]
Enable
Disables NSM debugging.
no debug nsm {events | kernel}
no debug nsm ha
no debug nsm packet {send | recv} [detail]
no debug nsm packet [detail]
To display the debugging information, use the following command.
Command
Mode
Description
show debugging nsm
Enable
Global
Shows the debugging information of NSM.
To disable all debugging, use the following command.
Command
Mode
Description
no debug all [ipv6 | nsm | ospf |
rip]
Enable
Disables all debugging.