Dasan V8102 - Rebooting Ius; Default os of Ius; Displaying Ius Information

UMN:CLI User Manual
V8102
88
Step 3 Register new IU in the slot.
Command
Mode
Description
slot planning iu SLOT_NUMBER {siu-gpon16 |
sfu-10ge4}
Global
Specifies an IU type in a slot.
Step 4 Replace the old IU with the new IU. Insert new IU into the intended slot.
Step 5 Change the admin state to ‘unlock’ for specified slot number with slot unlock siu com-
mand to make IU activating in the system
5.2.3 Rebooting IUs
To restart the specified IU, use the following command.
Command
Mode
Description
slot restart iu SLOT_NUMBER
Global
Restarts an interface module in the specified slot num-
ber.
To turn the power on/off of a specific IU, use the following command.
Command
Mode
Description
slot power iu SLOT_NUMBER
{on |off }
Global
Powers on/off an interface module in the specified slot
number.
slot power sfu mate on
Powers on the standby SFU module.
5.2.4 Default OS of IUs
To set the default OS of the IU, use the following command.
Command
Mode
Description
slot default-os iu
SLOT_NUMBER {os1 | os2}
Global
Sets the default OS of the IU.
(default: os1)
5.2.5 Displaying IUs Information
To display information of the specified slot, use the following command.
Command
Mode
Description
show slot cpuload iu
{SLOT_NUMBER | all}
Enable
Global
Shows the specified slot information.
show slot memory iu