Dasan V8102 - Additional TACACS+ Configuration; TACACS+ Server; TACACS+ Server for System Authentication; TACACS+ Server Priority

UMN:CLI User Manual
V8102
294
no login radius retransmit
Deletes a specified frequency count.
8.3.6 TACACS+ Server
8.3.6.1 TACACS+ Server for System Authentication
To add/delete the TACACS+ server for system authentication, use the following command.
Command
Mode
Description
login tacacs server A.B.C.D KEY
Global
Adds a TACACS+ server with its information.
A.B.C.D: IP address
KEY: authentication key value
no login tacacs server [A.B.C.D]
Deletes an added TACACS+ server.
A.B.C.D: IP address
You can add up to 5 TACACS+ servers.
8.3.6.2 TACACS+ Server Priority
To specify the priority of a registered TACACS+ server, use the following command.
Command
Mode
Description
login tacacs server move
A.B.C.D <1-5>
Global
Specifies the priority of TACACS+ server.
A.B.C.D: IP address
1-5: priority of TACACS server
8.3.6.3 Timeout of Authentication Request
After the authentication request, the V8102 waits for the response from the TACACS+
server for specified time. To specify a timeout value, use the following command.
Command
Mode
Description
login tacacs timeout <1-100>
Global
Specifies a timeout value.
1-100: timeout value for the response (default: 5)
no login tacacs timeout
Deletes a specified timeout value.
8.3.6.4 Additional TACACS+ Configuration
The V8102 provides several additional options to configure the system authentication via
TACACS+ server.
i